Our polycarbonate glazing bars are snap-down, rafter-supported glazing bars for polycarbonate roofing sheets. They hold and seal the sheets on carports, lean-to roofs, patio canopies, pergolas and conservatory-style roofs. Each bar screws along a timber rafter, the sheet edges sit on its gasketed base, and the uPVC top cap snaps down to clamp the sheets and keep the joint watertight. Choose white or brown bars for 10mm and 16mm sheets in 1.5m to 6m lengths, or anthracite grey bars for 10mm, 16mm and 25mm sheets, plus matching glazing bar end caps.
Which glazing bar do I need?
| Glazing bar | Sheet thickness | Colours | Lengths |
|---|---|---|---|
| Snap-down glazing bar | 10mm and 16mm | White, brown | 1.5, 2, 2.5, 3, 3.5, 4, 5, 6m |
| Snap-down glazing bar | 10mm, 16mm and 25mm | Anthracite grey | 2.5, 3, 4, 6m |
| Clip-in end cap | To suit the white, brown or anthracite grey bars | Single cap | |
Using 25mm polycarbonate sheets? Choose the anthracite grey bar. For 10mm and 16mm sheets, any colour fits.
What do glazing bars do?
Glazing bars are what make a polycarbonate roof watertight. Every joint between two sheets sits on a bar, and the outer edges sit on a bar too. The bar supports the sheet edge, seals the joint with rubber gaskets top and bottom, and gives the polycarbonate room to expand and contract in hot and cold weather without cracking or leaking. Without them, the sheets have nothing to seal against and will leak at every joint.
How many glazing bars do I need?
You need one bar per rafter: count the sheets across the roof and add one. Choose bars the same length as your sheets, or longer and cut them down. Example: a 3m-wide carport with 1050mm sheets needs three sheets and four glazing bars, plus four end caps for the eaves.
Space the rafters so every sheet edge lands in the centre of a rafter. Rafter centres are the sheet width plus a few millimetres for the bar, for example about 1060mm centres for 1050mm sheets.
How to fit snap-down glazing bars
- Build the frame with a fall of at least 5° and set the rafters so each sheet edge lands on a rafter.
- Screw the glazing bar base along the centre of each rafter.
- Seal the sheet ends with aluminium tape, breather tape and end closures.
- Lay the sheets on the bars, UV-protected side up, leaving a few millimetres of expansion gap at each bar.
- Line up the top cap and snap it down with a rubber mallet, working from the top of the roof down.
- Clip an end cap into the bottom of each bar to finish the eaves.
Delivery
Glazing bars are delivered by specialist courier to UK mainland addresses, typically within 5–10 working days. They share delivery with our polycarbonate sheets: a flat £29.99 per order, free on orders over £300, so order your bars and sheets together. End caps come with free UK delivery. Long lengths need clear access for delivery.
Complete your polycarbonate roof
You will also need multiwall polycarbonate roofing sheets in 10mm, 16mm or 25mm, and sealing tape and end closures. Building the frame? See our sawn treated timber for rafters and wall plates.
